I've several spools of ribbon, wire, and tape that have been floating around the craft room and making mess!
So I turned an orange crate into a handy little holder!
You will need:
- a wooden crate (I used a 5lb clementine crate)
- wooden dowels or unused knitting needles
- a nail, Xacto knife, screwdriver, or other sharp object
- paper
- Modge Podge
- paintbrush
- your collection of ribbons, wires, tapes, or anything else on spools
Step Two: Poke some holes in the crate.
This is the most difficult part. I used an Xacto knife and an old nail. Smarter people can use a screwdriver.
Make sure that the holes line up and that your dowel/knitting needle can fit through it.
Step The Third: Prepare your paper...
We have many pretty papers but I was in love with the Asian designs on some of my fabric. So I photocopied the fabric. 'Cause it works. Just let the ink dry completely.
The Fourth Step: Mod Podge the paper on.
Paint a layer of glue on the crate. Press the paper on and get rid of bubbles. Let it dry for 2 minutes and then paint on a top coat of glue.
You could use a different glue but Mod Podge would work the best.
Step Five: Slide the ribbon on!
Here you can see that I used a knitting needle in the middle. This works wonderfully if you don't have wooden dowels on hand.
Enjoy your ribbon holder!
I use mine for more than just ribbon-- tape, wire, and even a bobbin are all on there. Just wait until we unpack that other box of craft supplies. Mom has many spools of ribbon!
Tip: A small bit of Scotch tape or a sewing pin go a long way. Use it to keep your ribbon attached to the spool. (Unless you are itching for a mess to clean up, that is!)
Let me know if you try this tutorial! Leave a link in the combox (comments box) with a link to your own blog post or to a picture!
Linky, linky, linky! I'm linking up at these parties.
Linky, linky, linky! I'm linking up at these parties.